|
|
|| Amplifiers - Booster / Power / Two Zone / Instrument || Audio Mixer - Echo / Stereo || Conference Systems || |
|
|| Cassette - Player / Recorders / Preamplifiers || Driver Units || Horns - Reflex / Speaker || Microphones || Mobile PA || |
|
|| Speakers - Ceiling / Column / System / Wall / Professional || Sound System || Stand - Floor / Table / Accessories || |
| CATALOG | |||
|
|||
| PAGE-3 | |||
|
|||
|
REAR PANEL CONNECTION & CONTROLS
|
|
13
/ MIC INPUT JACKS:
Input jacks of 6.3 mm (1/4’’) are provided to receive signals from
Mick-1, Mick-2, Mick-3,& Mick-4(Lo-Z type). The respective volume
controls switches of each is at the front. See page 5.
14,
15 / MICROPHONE/ AUX CONTROLS :
Mick-5/ AUX 1, Mick-6/ AUX –2 Jacks .These will receive signals either
from microphones (Mick-5 & Mick-6) OR from Cassette Players, Mixer etc.
In each Jack only one mode can be plugged at a time. The Respective controls
and selector switches are at the front panel . See page 5
16
/ PRE-AMP OUTPUT :
Input jack is for Cassette Recorder to record the entire programme being fed
to the amplifier from microphone. Booster Amplifier can be attached for more
power. See page 6
17
/ LINE OUTPUT :
6.3 mm (1/4’’) Input jack to connect Booster Amplifier for more power
output. See page 6
18
/ OUTPUT TERMINALS FOR DIRECT SPEAKER CONNECT :
‘COM’ 4-8-16 Ohms Terminal are for Direct speaker Connection. Connection
should be made to only one impedance i.e. either COM & 4 Ohms or COM
& 8 Ohms taps or COM & 16 Ohms taps.
19 / OUTPUT TERMINALS FOR 70 V-100V LMT SPEAKER CONNECTIONS : 70 V-100 V Line Speaker terminals for use with Speaker fitted with 100 v line Matching Transformer. See page 8 20 / CIRCUIT PROTECTOR : In event of any short circuit in speaker wiring or overloading of amplifier, the circuit protector will trip the system & protect amplifier form damage. See page 6 21 / 24 VOLTS BATTERY TERMINALS : 24 V Battery Connections to provide ‘STAND BY’ power source ( 2 x 12V Car Batteries- in series). 22 / GROUND EARTH TERMINALS : Earth connector for connecting to water pipe / earthing. 23 / AC FUSE : AC Fuse / 4 Amps. 250 V Always keep the Fuse Holder tight for good connections. 24 / AC MAINS CORD : AC Cord for connecting to 240 V - 220V AC Mains,50-60 Hz supply. |
|||
|
|
|| Amplifiers - Booster / Power / Two Zone / Instrument || Audio Mixer - Echo / Stereo || Conference Systems || |
|
|| Cassette - Player / Recorders / Preamplifiers || Driver Units || Horns - Reflex / Speaker || Microphones || Mobile PA || |
|
|| Speakers - Ceiling / Column / System / Wall / Professional || Sound System || Stand - Floor / Table / Accessories || |
|
Due to continuous design & technical development specifications are subject to change without notice. |